Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2003 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Small Clock Wiring Harness 200 1989

Guys,

I pulled a small clock out of a wreck this weekend, but I didn't get the harness to the Tach. I know which wire goes where, but what size wire do I need? Last time I did something like this I melted my dash (long story).

PS: Is the guy who pulled the center armrest from the 86 244 in the Pick 'n Pull on Buford Hwy (Norcross GA?) on this board? (I saw you leaving) How much do you want for it? It matches the seats.

Terry
(back home in Indiana)








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Small Clock Wiring Harness 200 1989

"...but what size wire do I need?"

The clock and its panel light draw almost no current. 22-24 gauge wire would more than enough. Your main concern is using wire that has sufficient mechanical strength.
--
Don Foster (near Cape Cod, MA)








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Small Clock Wiring Harness 200 1989

Damn that was fast, Thanks a lot!

Terry.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.