Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

A\C Belt (Install) 84 B23 200

posted by  Bruce S. on  Mon Jul 29 16:25 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 4 19:05 CST 2014
[RELATED]

Hello All,

I'm just finishing up my first timing belt install, and I've got a new a\c belt, size 13x925. What is the proper way to install it? If I put one end around the compressor and then try to sandwich the the two halves of the pulley together using the four shims I found in there the belt seems to small. It rides very deep in the groove, deeper than the old one, and I'm afraid that I'm squeezing the belt and the pulley halves are not bottoming out. Or should I bolt the pulley together, and then some how bump the belt on? Thanks in advance.
--
Bruce S. near D.C.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New A\C Belt (Install) 84 B23 [200]
posted by  Bruce S. subscriber  on Mon Jul 29 16:25 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.