Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2014 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Quick ?, can 740 tranny go in 240 car..... 200

I've got a 89 240 that kind of slips into reverse, takes a few seconds to engage and kind of bangs in. Also have a dead 760 tubo with a good tranny. Seems to me the tailshaft has to be swapped. Is that right? does anyone know the preocedure to swap these two trannys. All help appreciated. TIA Tom 240aholic








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Quick ?, can 740 tranny go in 240 car..... 200

Remove the single bolt holding the output flange. Swap flanges (I would replace the seal while it's apart) and reinstall the bolt. Don't have to swap the tail shaft, just the flange.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.