Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2005 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

weird volvo thingy drawbar receiver ballmount - sizes?? 700

I'm going to let that POS weld in a local shop - maybe.
Have to get a quote first.

Anybody knows the sizes?
I know its 3.25 x 2 inch, but how long?
Where are the pinholes?
Is it closed at the rear end?
What steel / alloy ?

Has somebody a photo?

Anything else to be considered?

TIA
--
GN Long Beach 745 1986








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

weird volvo thingy drawbar receiver ballmount - sizes?? 700

Have you checked IPD? You might be about as well off to order one of their stock hitches. Or there are generally local shops which stock hitches that work just fine. You might be about as well off financially, and if you care about looks . . .








  REPLY TO THIS MESSAGE    PRINT   SAVE 

weird volvo thingy drawbar receiver ballmount - sizes?? 700

When I recently measured the "weird volvo thingy drawbar receiver ballmount" female part (that's the one with the "insy," right?) with my cheap vernier caliper I took it to be a nominal 5 cm x 8 cm. That 5 cm is a very shy 2" -- no go with 2" stock, sorry!
--
Gregg in MN







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.