Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2007

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Turbo Oil Cooler Center Bolt

posted by  someone claiming to be ringlee on  Fri Aug 30 14:00 CST 2002 [RELATED]

Anybody have the torque spec for the center bolt that holds the oil filter can adapter to the remote fitting? This is the one into which the filter screws. My kid's unit keeps leaking right at that joint and I suspect he has rotated the bolt out along with his filter. Next time, I am going to clean it off and use Loctite to secure it. Yes, the o-ring is new.








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Turbo Oil Cooler Center Bolt

    posted by  dick on  Fri Aug 30 15:31 CST 2002
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
    last visit: Sun Aug 3 15:24 CST 2014
    [RELATED]

    Just took care of a leaking unit on wife's 91 turbo. Had to do it twice and still don't know what it did. Torque is not going to be important as you are only compressing an O ring. When I replaced the O ring the second time, it did not leak. I question if I may not have had it in properly the first time. Fortunately, it can be removed without too much grief.

    dick







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.