Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2006 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Is there a good way to get the black vinyl stuff off the top of the door? 200

I am replacing the passenger doors on my turbo, but the vinyl blacking out is different on both doors and neither match the trim on the turbo. Is there any trick to getting it off. It does not seem to peel off very well. Yo might say it would be easier to get matching doors, but rust free doors are hard to come by where I live.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Thanks, never thought of heat would have been scraping for hours 200








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Is there a good way to get the black vinyl stuff off the top of the door? 200

In preparation for painting the flathood, I had to remove this stuff. We were worried about the time it could take but 5 minutes with a hair drier and it peeled off just as easy as pie.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Is there a good way to get the black vinyl stuff off the top of the door? 200

Use a heat gun or hair dryer. WD40 or Goo Gone is good for getting rid of remining adhesive.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.