Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2008 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Preload on Clutch spring 200 1989

Want to pull the pedal off to grease up and rid myself of the squeak. It just looks like with the pedal 'out' that there is a lot of preload on the spring. Am I going to get the pedal off and not be able to wrestle the spring back onto the pedal?
--
'75 Jeep CJ5 345Hp ChevyPwr and two motorcycles: it wasn't Volvos safety , it was Longevity that sold me








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Preload on Clutch spring

    Sounds like a lot of work to get rid of a squeek.

    Buy some chain and cable lube in an aerosol can from any motorcycle shop or from NAPA. It is heavy grease dissolved in light solvent, so it penetrates and then sets up to a heavy grease.

    I use chain and cable lube on just about every moving joint on the car, such as door locks and hinges, etc. If you buy a cable lubricating tool from the motorcycle shop, you can force grease down the full length of your throttle cable, clutch cable, and hood release cable. It makes everything work like new again BUT IF YOU LIVE WHERE IT IS COLD, try this on non-critical cables first. My car never sees temperatures below freezing. I don't know how stiff that grease gets at -20F, and I'd hate for someone's throttle to stick open because of my advice.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.