Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2022 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Injector questions 200 1983

I replaced my injectors awhile back with some cheap ones from Autozone to fix what I thought was clogged injectors. Turns out that wasn't the problem.They fit in just like the old ones, but I'm wondering if they have a different flow rate.
Can this be the problem of my lean running condition? I'm thinking maybe I should swap them back? What do y'all think?
--
'83 244GL 210K








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Injector questions 200 1983

Mark, don't they have numbers? It has been a few years, but I thought I read somewhere even among LH Jetronic variations different injectors are used, not only flow rate differences but electrically too.

If you can find the part numbers, I believe you can also find reference for the coil characteristic and flow rates. Or maybe I can.

On the other hand, it wouldn't be maybe an hour to swap them and see if you get different response at your oxygen sensor or mixture test point. What a kicker if that caused NOx to be high??
--
Art Benstein near Baltimore







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.