Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2007 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

quick rear axle swap question ? 2dr gl/gle to wagon gl ? 200

found a fellow w/ a couple early 80's 2dr gl & gle 240's. any forseable problems with transplanting one of his rear ends into my '82 245GL wagon ? different attachment plates at the driveshaft, mounting points, spring perches, etc ?
thanks again =)
--
-- '82 245GL, B23E, K-cam, under restoration, 350k km --








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    quick rear axle swap question ? 2dr gl/gle to wagon gl ? 200

    Bolts right in. No issues, other than ratio changes affecting your speedo.
    You may have to change the speedo drive gear in your trans to get it correct.

    Determine the axle ratio this way:
    block one wheel from turning or jack just one wheel up. Leave the other free to spin (assuming no limited slip, fairly rare). Put trans in neutral, park brake off. Mark the driveshaft yoke with white-out or another visible mark. Turn your free wheel exactly 20 rotations in the same direction. COunt the rotations of the driveshaft. Estimate the last fraction of a turn based on where the mark winds up. Divide the result by 10 for the ratio. SO: 20 turns gives 33 and about a half a rotation of the driveshaft= 33.4 turns /10 = 3.34 axle. It's simpler than it sounds. Interested to know what you find.
    --
    Rob Bareiss, New London CT ::: 86 244DL, 87 244DL, 88 744GLE, 91 244: 808K total








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      quick rear axle swap question ? 2dr gl/gle to wagon gl ? 200

      As AQye Roll said, it'll bolt right in. However, two different size drive shafts were used based on engine/trans combos. You may have to swap the flange for the drive shaft mount.








      •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

        quick rear axle swap question ? 2dr gl/gle to wagon gl ? 200

        how big of a swap is this ? i had to swap the flange when i replaced the tranny, same thing ?
        one big nut on a splined shaft & a bit of co-ercing w/ a rubber mallet ?
        thanks
        --
        -- '82 245GL, B23E, K-cam, under restoration, 350k km --








    •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

      quick rear axle swap question ? 2dr gl/gle to wagon gl ? 200

      so long as it physically works, i couldn't care about ratios or it affecting my speedo .. have a gps that i can use to figure out the speed diff. & i'm pretty sure my wagon already has the highest gearing in it. 120km/hr @ 3-3100rpm.
      --
      -- '82 245GL, B23E, K-cam, under restoration, 350k km --







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.