Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2021 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

hood release cable removal 200

how to? haynes was not much help.is there a special tool,or trick to removal of hood release cable w/housing from firewall?








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

hood release cable removal 200

Searching,

You don't mention the year; they changed the release in 1990 I believe. I've done this before but it was a long time ago and on a pre-90 240, and Philvo's description doesn't elicit any deja vu, so I wonder if you guys are talking about the release with the lever or the white knob.

What I do remember is the firewall retainer for the white knob version is a snap in device where the fingers of the plastic grommet must be carefully released from the firewall hole or they will break. Then, the hole is large enough to withdraw the cable and its end hook back into the cabin.
--
Art Benstein near Baltimore








  REPLY TO THIS MESSAGE    PRINT   SAVE 

hood release cable removal 200

Disconnect the pull handle and then pull the cable thru the firewall from the engine bay.The rubber grommet will pop right off.
--
philvo







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.