Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2007 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

B23F & B230FT similarity questions 200 1984

Currently I've got a standard B23F motor in my 84 242, but I read on this message board that the intake manifolds and exhaust manifolds are interchangeable for the B21, B23, and B230 motors. Going on that, I got lucky this weekend at the junkyard and bought a 740 turbo exhaust manifold and turbocharger for $100 (turbo is in bad condition, but I've got another T3 already, so it was just for the turbine and compressor housings, exhaust manifold looks to be in good condition).

Anyways, I didn't have time to get the intercooler and the oil lines off before they closed, but I plan on going back this Saturday to scavenge some more.

My questions are:
1.Are the pistons interchangeable between the B230FT and the B23F?
2.Will the B230FT oil pan fit the B23F block (so I don't have to tap the oil lines)?
3.Is the intake manifold significantly different on the B230FT (I noticed a location for where the turbo bypass valve empties back into the manifold)?
4.Are the valves swappable (I assume the turbo has sodium-filled valves)?
5.Does anyone know of a decent turbocharger rebuild shop in Southwest Virginia (there's one in Salem, they claim to be Garrett authorized, but I'd like to have options)?








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

B23F & B230FT similarity questions 200 1984

Read this thread, and browse some of the related topics over at Turbobricks. Basically, you can run low boost (~5PSI) on a stock B23F - stock LH-Jet, ignition, etc...

1)Yes, B23FT pistons can be swapped into a B23F. Ask for Kenny at T-bricks.

2)The oil return line enters the block on a B23FT. The common solution is to add the fitting to the B23F oil pan (carefully - must flow freely or turbo will smoke.)

3)The intake manifolds are identical. There may be some fittings in place on one and not the other, but it is all swappable.

4)Valves can be swapped, but that is a lot of work. You might just swap an entire Turbo head. I picked one up for $30.

5) Nope, sorry.
--
Speed Racer, '83 240 R, '74 164 E, '93 940 OL1 (Manchester, CT)








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

B23F & B230FT similarity questions 200 1984

Oh, and I had one more question: Will the valve cover off the 740 Turbo (black with white letters) swap onto my B23F engine?







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.