Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2014 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Break noise 200 1987

posted by  myoder on  Sun Aug 3 17:13 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Mar 5 12:40 CST 2013
[RELATED]

I replaced the rear break pads but did not replace the hardware, (i.e. the clip and pins) and now when I press the breaks sometimes it makes a clunking noise. If I replace this hardware will it stop the noise?








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Break noise 200 1987

posted by  TONY H on  Mon Aug 4 06:49 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 16:39 CST 2014
[RELATED]

Are you sure you push the pins allll the way in??

I don't think anyone replaces the pins aspring clip unless they are bent, rusted or worse.

I lightly sand the road dirt off the pins and put a very light coat of Lithium grease on them.
--
'75 Jeep CJ5 345Hp ChevyPwr and two motorcycles: it wasn't Volvos safety , it was Longevity that sold me







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.