Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2007 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

'93 245...New shocks, bushings & sway bars...rear end now squeaks??? 200

I have just replaced all of the suspension bushings, shocks and F/R sway bars (IPD bushing kit, Boge Turbo and IPD HD F/R sway bars) on my '93 245. It handles much better, but there is now a very noticeable squeak from the rear at slow speed in both reverse and forward gears. What's up with that? This only became apparent after we installed the bushings (had a shop do the installation). Is it possible to incorrectly install the bushings? Thoughts from the Board?

JC








  REPLY TO THIS MESSAGE    PRINT   SAVE 

'93 245...New shocks, bushings & sway bars...rear end now squeaks??? 200

Do you know if the shop when installing the new bushings first tightened the bolts finger-tight, then lowered the car and bounced it a bit, and only then torqued to spec?

Erling.
--
My 240 Page








  REPLY TO THIS MESSAGE    PRINT   SAVE 

'93 245...New shocks, bushings & sway bars...rear end now squeaks??? 200

I don't know if they tightened by hand 1st, lowered, bounced and then torqued the bolts. I do know that they said that they had a very hard time getting the bushings out of the car and had to keep the car overnight to let their version of pb blaster work on it. I just had them retorque the bolts today, but it still squeaks and has a rattle in the back which I can't put my finger on. Very frustrating....John








  REPLY TO THIS MESSAGE    PRINT   SAVE 

'93 245...New shocks, bushings & sway bars...rear end now squeaks??? 200

If all is tight as suggested, sometimes new bushes will squeak a bit a first, but should diminish with time. A squirt with a pure silicone product helps without hurting anything.
Does it do it when you bounce the stationary car? (good diagnostic with head under car)
--
Paul's Amsoil and other lubricants








  REPLY TO THIS MESSAGE    PRINT   SAVE 

'93 245...New shocks, bushings & sway bars...rear end now squeaks??? 200

It squeaks if I push will very slight pressure on each side on the rear. Just a little push will produce a squeak.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

'93 245...New shocks, bushings & sway bars...rear end now squeaks??? 200

Have a bud do that while you listen around.
--
Paul's Amsoil and other lubricants








  REPLY TO THIS MESSAGE    PRINT   SAVE 

'93 245...New shocks, bushings & sway bars...rear end now squeaks??? 200

I had squeaking in the back of my 88 245 after doing the bushings and shocks. Turned out to that the top mount on one of the shocks was just a bit loose.
--
David Brick, Santa Cruz CA








  REPLY TO THIS MESSAGE    PRINT   SAVE 

'93 245...New shocks, bushings & sway bars...rear end now squeaks??? 200

Dave,

Thanks..sounds reasonable. I'll check it out tomorrow...John








  REPLY TO THIS MESSAGE    PRINT   SAVE 

'93 245...New shocks, bushings & sway bars...rear end now squeaks??? 200

Hmph. That's funny. Last fall I did all the exact same work myself and have the same result. I even torqued everything according to the manual. I had figured that something might need a little more. Will check mine out soon.

-Chris
--
88 245 DL (185k miles) | 98 S90 (75k miles) | 98 V70 AWD (86k miles)







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.