Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Fuel Sending Unit Question - '89 245 200 1989

posted by  ZenArt Glass on  Sun Sep 14 05:00 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I needed to replace the in-tank transfer fuel pump, as it was no longer functioning.
The top of the sending unit was covered in rust/corrosion ,so I used a brass brush to clean most of the rust off. As I was removing each rubber hose from the top of the sender unit the metal fuel hose/piping that is attached to the top of the sender unit itself snaped off. The place where it's snaped off is flush with the top of the sender unit.

My questions are:
Is it easliy repairable?
Do I need a new fuel sending unit?
And if I do, I assume I attach the new pump and filter to this and pop it back in.

I've been hunting around and found one online for $80 from http://www.volksparts.com/V240.htm

Thanks
Andy
--
Andy - 1989, 245DL Automatic Wagon, 225k miles, Branford, Connecticut






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Fuel Sending Unit Question - '89 245 [200][1989]
posted by  ZenArt Glass  on Sun Sep 14 05:00 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.