Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2004 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

An engineering question 200

The "way back seat" on my 245 is behind the rear axle. Does this mean it's within the crumple zone?

Thanks as always.

Jim
--
'92 Red 245 "The Radio Flyer"








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

An engineering question 200

I thnk it's obvious that the child seat is not the optimal place to be in a rear-end crash -- it is an a "crumple zone" of sorts -- but two mitigating things: the rear of the station wagon is not as sacrificial a crumple zone as a sedan's, as those "D" pillars are quite robust, far far more than the more flexible sheet metal of the sedan's trunk. And also (assuming you're not being rear-ended by a tall SUV), the lower rear of both sedans and wagons have a clever alignment of the lower frame* and a heavy piece of metal extending, via the rear brake calipers, to the heavy rear axle -- this absorbs and redirects energy of the impact into the massive axle, protecting the rear compartment's structural integrity.
[ * yes, I know the car doesn't really have a frame, but it has what would be called "stringers" if it was a boat, used to provide rigidity or, in the case of a car, dissipation of crash energy.]







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.