Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2023 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

replacing O2 sensor 700

posted by  servano on  Fri Oct 31 09:27 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I am about to replace the O2 sensor on my car but I can't find it's under hood wires. The faq says there should be a red spade connector with two blue-ended wires coming in each side near the oil dip-stick but I don't see any such connection on my 740Turbo. Are the O2 wires routed different on a Turbo (like how the radio relay got switch to the other side on Turbos's) ??
THanks, servano
--
87-740T (B230FT w/Garrett) 142k








  •   REPLY TO THIS MESSAGE    EDIT   PRINT   SAVE 

    posted by  someone claiming to be on  Wed Dec 31 18:00 CST 1969 [RELATED]

    On an 87 760T the O2 sensor can be seen/felt from the pax side, downstream from the turbo. It's screwed into the downpipe.

    On ours the two connectors were up on the firewall clipped, right above the distributor. One connector for the black signal wire and one connector for the twin white heater wires.


    Mark this post as an answer to my question<- Use this feature to mark quality replies to your post.




<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.