Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2002 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

760T where does large hose go? 700

Just finished a head job on my 1986 760 turbo. Got everything hooked up except the large rubber hose with the foam shield that runs from the turbo air intake over the valve cover into the intake manifold area. I have looked and looked and can't find the place to plug the hose! My Chilton's doesn't describe it either. Anyone know where it is supposed to go?

Thanks!

Alan Nichols








  REPLY TO THIS MESSAGE    PRINT   SAVE 

760T where does large hose go? 700

On our car it goes from the elbow with a little vacuum nipple on it (the vacuum nipple is for a small hose that then goes to the intake manifold) to the oil trap (doghouse sitting under the intake manifold on the engine case). The other end goes to the intake hose...there should be a 1/2" or so nipple. It goes on top of the cam cover.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

760T where does large hose go? 700

Found it, thanks!

Alan








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

760T where does large hose go? 700

It plugs into the Y fitting which sits on top of a short hose attached to the oil trap.

If my digital camera was back from the repair shop I'd take a picture for you.
--
john







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.