I think i rember seeing some one on here telling how to make a code reader for this car but i can't seem to find it. so if any one can let me know where to find that info or E mail it to me that would be great also here is a list of other questions
4 Cyl TI 4 speed manual with 5 as OD nearly 300,000 miles

some times when the car isent wormed up i cant seem to get the OD to work i hit it and it says it's in 5th and if you let off the gas the RPM's fall. but it's still in 4th any ideas?

also i rember some one posting on how to build an Air/Fuel read out useing LEDs and now that i have my new car i want to build that.

also has any one turned there turbo up to 12-14 LBS? i have a blow off valve but around 12-15 lbs the car seems to lurch slightly but i'm not shure if it's the car or just wind or what.

thanks in advance guys
gary_walter@hotmail.com

"some times when the car isent wormed up i cant seem to get the OD to work i hit it and it says it's in 5th and if you let off the gas the RPM's fall. but it's still in 4th any ideas?"

Your overdrive needs to have the o-rings replaced, especially on the actuatting pistons. See the 700/900 FAQ.
--
john

Code readers don't exist, since the system is manual. See the 700/900 FAQ for information on codes and diagnostics. More information there on overdrives as well.

Thanks very much guys.
as for the air fuel ratio meter i found how to build one and it looks pretty neat.
i was also thinking just for fun of connecting LEDs with a 750 ohm resistor
to each of my injectors. then running them inside into a switch blank not that it would do Any good but it might look kind of neat.
as for the *Code reader* i should have made that more clear. what do i need to do to build some thing to get the blink or flash codes i assume some sort of led set up... and ....? plus i'm unshure of what pin to plug it in to... maby if i stay up till 7 am today i'll figure it out but if some one could give me a schematic or point me to a URL that would be Great.


Thanks , Gary