Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2002 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

240 stays running when ignition off 200 1981

For the last couple of days my brick doesn't turn off when I turn it off (if that makes sense). Not dieseling, just stays on. It's a manual so I stall it with the handbrake on. Anyone seen this?
--
__Stef; 81 DL wagon B21A SU carb 313k








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

240 stays running when ignition off 200 1981

Slight chance it is the degraded wire harness, be careful of that possibility as it can get deangerous fast. My '85 turbo had the same tendency with the bad harness, running on with the key off a couple of times.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

240 stays running when ignition off 200 1981

That was my experience ('81 245). I haven't been able to replace the wiring harness yet, but coated the (bare!) wires around the starter with silicone as a temporary fix. In my case the starter wouldn't disengage, but other times the engine would just die. So shorts can cause a variety of problems!








  REPLY TO THIS MESSAGE    PRINT   SAVE 

240 stays running when ignition off 200 1981

Sounds like your ignition switch is bad. Happened to me before, went to pick & pull, paid $5 for the used switch, never had that problem again.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.