Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2013 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Most Common Causes of Rough Hot Idle with K-Jets? 200 1981

What are the most common causes of a rough hot idle on a K-Jet? Compression is good and even. Idle is much smoother when the engine is cold.
--
Thanks everyone for the advice. 81 242 Brick Off Blocks, Turbo bars and wheels, B21F, M46; 86 244, B230, 148k , auto.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Most Common Causes of Rough Hot Idle with K-Jets? 200 1981

It is running a bit lean more than likely, and vacuum leaks are a good place to start. Also a simple adjustment of the air flow sensor may cure it. If that doesn't do it, then the injectors should be checked for spray pattern - pull them out, energize the pump, and lift the air flow sensor plate manually. A visual check is all that is needed to spot a bad injector or two.








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Most Common Causes of Rough Hot Idle with K-Jets? 200 1981

Once vacuum leaks are eliminated, what other things would be the most likely cause of a rough hot idle? I want to get this thing running as smoothly as possible.
--
Thanks everyone for the advice. 81 242 Brick Off Blocks, Turbo bars and wheels, B21F, M46; 86 244, B230, 148k , auto.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Most Common Causes of Rough Hot Idle with K-Jets? 200 1981

Vacuum Leaks







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.