Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2005 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Motor Mounts 200

posted by  someone claiming to be Roy on  Sun Jan 16 10:36 CST 2005 [RELATED]

Trying to change motor mounts on 1984 240GL. I can get to passenger side ok. Driver side is different story. Removed top nut on pass side mount. Drivers side removed the three nuts that hold mount to frame. Used a floor jack to lift engine, but need at least another half inch. Any ideas on what I'm doing wrong? Thanks Roy








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Motor Mounts 200

posted by  daveshan on  Sun Jan 16 10:58 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Oct 19 07:03 CST 2014
[RELATED]

It's a whole lot easier if you unbolt the upper mount from the engine then remove the rubber while the mount is out. If you don't have a big vixe to hold the mount the upper nut should be loose before taking it out of the car.
--
Dave Shannon
Spring Valley, California
'65 1800S ????K
'67 1800s 79K
'73 1800ES 117K
'88-240 190K+
'92 745Ti 160K
my pages







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.