Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2002 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Splices in wiring harness 700

posted by  Big Harry on  Sat Feb 5 09:54 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Sep 21 11:06 CST 2014
[RELATED]

Take a look at this photo! When I cut the wrap from the harness on the 88 760, I found that all of the ground wiring to the ECU and the ground for the Coolant temp Sensor were all spliced to one wire which attaches to the manifold and then were buried in the wiring harness uinder the manifold. This would be an impossible situation to trouble shoot. I am going to put the in a multiple lug ground block on the passenger side of the engine and ground the lug to the engine block. If you are having intermittent problems with the fuel side of the system, this is worth a look. It definitely is not a sound electrical practice.

Regards,

Will Dallas
--
Will Dallas








<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.