Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2009

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Fat guy bent my drivers' seat

I have a 88 240 with blue vinyl seats, and the drivers seat has a bad lean to it(leans towards the center) I think the previous owner was a portly fellow, and the seat was bent over the course of 140,000 miles....whatever the cause, is there a way of fixing this without replacing the seat. Has anyone run into this problem? Thanks
--
1995 855 T5, 1992 245, 2003 Mini Cooper








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Fat guy bent my drivers' seat

When I tried to bend my seat back, it did not stay. As I looked at it, it reminded me of a gate or door that was sagging. So I ran a piece of wire diagonally, like you would to brace a sagging gate. There were two holes in the frame that were in the right locations.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Fat guy bent my drivers' seat

Remove the cover and rebend the wire frame inside.

Such said, it may be easier/cheaper to pluck a seat from the junkyard and just swap the cover over.

-- Kane







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.