Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

More Crank case pressure questions. 200

posted by  joe pulkowski on  Fri Sep 2 03:41 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Oct 27 07:53 CST 2013
[RELATED]

Thanks for all the info to date.
I did more trouble shooting. So far Ive installed, New Oil separator, new flame trap s-hose, new hose from nipple to flame trap, new flame trap, new hose from flame trap to intake hose, new intake hose, new IAC hose, cleaned all nipples in the intake, new oil filler cap and seal.

I disconnected the larger hose that goes from the flame trap to the intake hose. When I blow into the large hose from the flame trap to the intake, I can hear the oil bubble in the pan, and feel the air flow out of the filler hole. With the engine running, I feel a slight vacuum on the hose, defintitly not positive pressure.

I disconnected the small hose from the from flame trap to intake nipple, and dont feel anything comming out of when the engine is running.

Is this a symptom of a stuck valve?

Valves need adjustment? I think its been over 100,000 since I checked the valve clearances.

Is there something I can check?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New More Crank case pressure questions. [200]
posted by  joe pulkowski  on Fri Sep 2 03:41 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.