Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

driveshaft alignment.....2 halfs balanced together??? 200 1986

posted by  someone claiming to be chris with an '86 245 on  Mon Sep 19 02:33 CST 2005 [RELATED]

hey guys, i took the rear part of my driveshaft lose to replace u-joints. i had to take the rear half of the shaft out to do this. Should i have marked where that went in in relation to the front 1/2? i know these shafts are spin balanced and all. but would that be each half or the whole thing together? i thought i had my u joints alll figured out and fixed and put it back together and there is more of a vibration than there was before with bad ujoints. also, does the the rear yoke flange have to be matched up just the right way with the rear end flange also? or can that be bolted on at any rotation? This is really driving me nuts, please help!
Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New driveshaft alignment.....2 halfs balanced together??? [200][1986]
posted by  someone claiming to be chris with an '86 245  on Mon Sep 19 02:33 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.