Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2003 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

rpm sensor problem continues!! 900

posted by  someone claiming to be warrior on  Mon Sep 19 04:50 CST 2005 [RELATED]



Greetings fellow Bricksters
First let me thank everybody for the help that you have provided up to
now. The problem still continues I have replaced 2 rpm crank sensors and
I still am not gettting any pulse (tach needle movement while cranking)
The only time it jumps is right when it starts,car runs fine. I tested
both new sensors and they read 179 ohms. It is a bosch ignition system,
92 940T. Unless that is the way these were designed but I doubt it based
on what I have read in the forum.I have replaced fuel pump relay, FPR,
plugs ngk v-power, wires bougicord,and radio suppression relay. Maybe
ignition coil, ignition module(POWER STAGE), might be going bad I do not
know. Please help if you can.

Thank you
warrior





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New rpm sensor problem continues!! [900]
posted by  someone claiming to be warrior  on Mon Sep 19 04:50 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.