Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2009 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Output Shaft Bushing Hole 700

posted by  zotparkerm on  Thu Sep 29 02:49 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jun 10 14:19 CST 2013
[RELATED]

I just replaced my output shaft bushing and for the most part was very studious when going over the FAQ.

I missed, however, the last couple of lines about the hole in the bushing going straight up and NOT lining up with one of the grooves. Unfortunately, the transmission shop where I took it to have the old bushing pressed out and the new one replaced did line the hole up with the lowest groove. I asked about it and he said that was so some fluid COULD get into the bushing and lubricate it.

Is this wrong? What's the result of that hole being lined up? Do I need to redo this whole operation?

Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Output Shaft Bushing Hole [700]
posted by  zotparkerm  on Thu Sep 29 02:49 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.