Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

rear suspension bushings 200 1986

posted by  someone claiming to be George on  Sat Oct 1 09:05 CST 2005 [RELATED]

Hi All,

Had the rear trailing arm bushings replaced about 4 years ago and thought that they had gone bad again because a clunking noise. What I have discovered is that the bushings for the torque or support rods are shot. I can even rock the differential back and forth a little bit. So how hard is it to replace these bushings? Does it require the rods to be taken off and taken to a place that can press them in or can an average DIY do it? Thanks in advance. George






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New rear suspension bushings [200][1986]
posted by  someone claiming to be George  on Sat Oct 1 09:05 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.