Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Does Volvo use 18 mm hardware anywhere... 200 1991

posted by  mdouma on  Mon Nov 7 08:01 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 18 15:10 CST 2013
[RELATED]

but specifically the front end? I blew out my ball joint yesterday, and my 17mm won't fit over the three nuts holding the bottom of the joint to the control arm, and my 19mm seems just a bit slack, even the 6-point from my impact set. Guidance appreciated.

Marten






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Does Volvo use 18 mm hardware anywhere... [200][1991]
posted by  mdouma  on Mon Nov 7 08:01 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.