Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Headlight Wiring Improvements 200 1990

posted by  EdM. on  Wed Nov 30 12:47 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Apr 21 17:57 CST 2014
[RELATED]

I'm finally about to embark on extensive headlight mods, including installing quad rounds. I already have plans to install an extra relay to off of the terminal 56b of the step relay to shorten the path of power to the low beams by sending power from the junction block to the switched side of the new relay directly to the lights (cuts out the bulb failure sensor and several trips through the firewall).

On the high beam side, though, I notice that the path of power seems to be directly from the junction block, through the step relay to the high beams. Does it make any sense to install more relays for the high beams? I don't figure I could shorten that circuit, but I could provide power seperately to each side. Note, please, that there will be four bulbs lit when I have the high beams on, though I use them sparingly.

-EdM.
--
'90 240DL Wagon 'Lola' -- '72 1800ES 'Galadriel'






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Headlight Wiring Improvements [200][1990]
posted by  EdM.  on Wed Nov 30 12:47 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.