Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

240 strut removal 200 1989

posted by  Tavish on  Thu Dec 8 04:41 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I am replacing the control arm bushings, ball joints, tie rod ends and strut inserts on the front of my 240, and am wondering if it is possible to get the strut free (enough) of the wheel well to facilitate this without having to disconnect the brake lines. They are corroded and I would prefer not having to worry about breaking them.(I have spent enough money already)
Also, the struts are currently not equally positioned in the shock towers. Should they be in the same position relative to each other in the adjustment slots, or does it matter.
I would think that this condition would create a different toe-in angle from side to side.
Thank you for any help you can give.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 strut removal [200][1989]
posted by  Tavish  on Thu Dec 8 04:41 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.