Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Front end parts questions 200

posted by  Mr brick driver on  Fri Dec 30 06:24 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Jun 26 04:12 CST 2014
[RELATED]

I need to repalce some front end parts on my 1983 244 Turbo. The car needs new inner tie rods. I was thinking about just doing the outer one's while the car was appart. It will also need new ball joints and also sway bar bushings. These needs leave me to a couple of questions. What brands of replament parts should I obtain? How much of this work do you think that I can do my self? Can I just pull the car in my grage and put it on jack stands and repalce this stuff with basic tools and then take it to an allignment shop? Also, should I repalce the entire rack on the car, as the car has over 150k on it? Thanks for any information and happy bricking? Also, should I go with stock sway bar bushings or the IPD ones?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Front end parts questions [200]
posted by  Mr brick driver  on Fri Dec 30 06:24 CST 2005 >
  • New / [200]
    posted by  Mr brick driver  on Fri Dec 30 14:57 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.