Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Reparing a voltage regulator by replacing the brushes 200 1991

posted by  Five Bricks on  Tue Feb 14 12:40 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue May 22 15:09 CST 2007
[RELATED]

I have an alternator voltage regulator with worn out brushes. The brushes are spring-loaded within a rectangular section sleeve. It looks like the wire attached to the brushes passes through a slitted tube that is crimped to hold it (the wire) in place. The wire/tube interface also appears to be soldered.

If I desolder the wire, will it and the attached brush come out, or do I also need to uncrimp the wire?

Thanks. I'm hoping to avoid paying $32 for a new voltage regulator. Especially when the brushes are only $3!
--
Seven bricks, yep, six!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Reparing a voltage regulator by replacing the brushes [200][1991]
posted by  Five Bricks  on Tue Feb 14 12:40 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.