Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2022 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Another timing belt install question 200 1986

posted by  Xraybob on  Sat Feb 18 11:33 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:32 CST 2014
[RELATED]

Tomorrow I will be doing my first timing belt installation. I have read everything I could get my hands on and feel I'm ready. I got my belt from FCP Groton and the belt they sent my is made by Roulunds Denmark and is a RO-DRIVE
stamped on the belt. I was surprised to see only 2 white marks not 3 on the outside of the belt. The other issue is that the original 2 marks look like they were blacked out with a black sharpie marker and new white line hand marked about 1/2 inch away from where the original ones were. Should I try to install this belt and if so, where do I line up the only 2 lines I have available?

Thanks in advance.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Another timing belt install question [200][1986]
posted by  Xraybob  on Sat Feb 18 11:33 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.