I layed under the dash today, and had my dad spary watter at the winshild. I found that waster was coming in the area of the hood relase open pull, wear it meets the firewall, the cruse control vaccume line wear it meets the firewall, and both driver's side heat hoses that come out of the firewall. Wow! What is the best way to fix this? Should I remove the heater hoses and crusie vaccume line and hood open pull, and repalce the gaskets, or should i fix then with some type of seal. I would feel better about repalcing the gaskets, but I'm a little worried about the complications of removing all that stuff. On the other hand, I would be worried about the potiential cause of rust, of useing a silicone type of seal. What would you do to fix this? Thanks for any information and happy bricking.