Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2000 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Inner tie rods made by Hamburg Technic, are they any good? 200 1989

posted by  JoeL99 on  Tue Mar 28 07:08 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Apr 13 12:19 CST 2009
[RELATED]

I have a 1989 240 with 200,000km or approx. 120,000mi on it. I am planning on replacing some of the front-end components with replacement parts from FCP Groton. Parts that I am planning on replacing are the Control arm rear bushings (Boge), Ball joints (TRW), Tie rod ends (TRW), and Inner tie rods (according to Rick they are made by Hamburg Technic). I believe Boge and TRW are of reasonable quality parts, am I correct? But I am not sure of the products by Hamburg Technic. Does anyone have experience with their products? I am trying to avoid spending time, energy and cost of an alignment on parts that are questionable.

Many Thanks,
Joe





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Inner tie rods made by Hamburg Technic, are they any good? [200][1989]
posted by  JoeL99  on Tue Mar 28 07:08 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.