Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2001 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

flex disc bolts on back of m46 at drive shaft. 700 1985

posted by  MarkyMark on  Sun Apr 16 16:50 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Dec 17 21:34 CST 2012
[RELATED]

gentlemen

I dropped the drive shaft and was going to remove the and replace the flex disc that sits between the back of the transmission and the front half of the drive shaft that has the center carrier bearing on it.

I was able to remove the driveshat bolts (3 hold the drive shaft to the flex disc and 3 hold the transmission to the flex disc...6 bolts total)
but unable to budge the other 3 that were mounted to the back of the tranny.

I used the rust spray about 6 times and heated them with propane torch about 3 times.

They wouldn't budge.....how do i get those stubborn sob's off?

I had to button everything back up w/o replaceing the disc which has cracks in it and is due for replacement.


Mark
85 740gle 240k w m46






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New flex disc bolts on back of m46 at drive shaft. [700][1985]
posted by  MarkyMark  on Sun Apr 16 16:50 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.