I've been concerned that my injection system thinks it's too cold and has been ramping up the fuel mixture too much.

I ordered a replacement coolant temperature sensor along with a few other parts I've been needing (crank position sensor for instance). The parts arrived today and I switched out the CP sensor with little trouble. I used a 19mm crecent wrench on the coolant sensor to no avail. I struggled with it for some time before I managed to bust the plastic plug housing. After a bit more struggling, I opted to go ahead and break off the housing to get a socket of the damn stuck thing. This worked... sorta...

Upon removing the old sensor and opening the bag containing the new sensor, I noticed that while it looked very similar, it was NOT the right size, nor was the connector the bullet-type. This part was the REAR sensor injector sensor, not the front gauge sensor!

Oh Shi...!! I've destroyed the sensor and have no replacement....

Ironically, it's the injector sensor that I needed to replace, but I destroyed the gauge sensor. I should have read my mauals a bit more carefully. Hard lesson.

But, I did bother to hang on to the B230F head and sensors from my 1986 740. I found the matching front sensor, removed it, but quickly noticed that instead of the twin bullet connector, it only has a single spade connector. It won't connect

Shi....!!! The dealer is closed here until morning

So... here are my short-term options.

1) Do nothing. Deal with an inop gauge for a while until I can get a replacement.

2) Jury-rig something with the 740's sensor.
I can make a quick spade-to-bullet conversion and make a temporary ground wire for the other bullet. In theory this should work...?

2) Waint, don't risk a potential overheat, leave the 940 in the garage and hitch a ride over to the dealer in the AM to buy the correct part. Actually, I can drive the frankenstein p1800.

I'm not sure what the consequences of an inopperative gauge would be. I'm guessing that the 940 has twin connectors because it controlls the fully electric fan. The 740 had a mechanical clutch fan. and would not have needed it.

Anyone know how much the 19mm bullet connector Temp Sensor costs from the Dealer??



--
1967 P220 Amazon, 1972 145S, 1976 245 DL, 1983 245 DL, 1986 745 GLE, 1990 745 GL, 1995 945....
You mean to tell me that Volvo makes cars that are *NOT* Wagons?!?
1971 P1800E... Not a wagon, but it's just a donor car for the Amazon..