Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2000 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

thermo contact valve problem 200 1982

I have a Problem with my car, its a 1982 240 with K- Jet Fuel Injection system and the story goes like this:

I start my car cold, every thing runs fine, the Idle air control starts kicking in and raises the RPM to 2,200 then gradualy lowers it to the 800 rpm idle speed,"This normally does it since I had the car". Then I press the throtle pedal and as soon as I release it the Idle speed rises to 1000 to 1100 RPM. Then I put it on drive and the engine drops its Idle speed barely beeing able to to stay runing, and sometimes dies completely then when it stays on it rises the rpm to 800. when I put it back in parking it rises to 1300 rpm and goes back down to 1000.

I had the curiosity of disconecting the wire from the Thermo contact valve and then everything gets normal again. Idle speed stays in 800rpm and the shifting problem doesnt ocure. Does this mean my thermo contact valve is defective if it is Where can I find one I've searched every local auto part store and they dont have it. What does this temp. sensor do? All my book says its called a thermocontact valve, its located below the thermal time switch and that it comes on 1982 to 1985 models.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.