Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2006 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Sway bar end link top nut torque value?? 900

posted by  miracleman49 on  Sun May 7 15:49 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Apr 6 15:53 CST 2011
[RELATED]

Replaced entire front suspension on 95 940 wagon. Torque value of sway bar end link top nut is: "tighten so that the outer flats of the washers are 42mm apart."

The washers on either end of the 'link pin to sway bar' bushings are not "flat", rather they are 'saucer' shaped. Meaning, there are TWO flats on each washer.

Can some PLEASE clarify which "flat" the torque spec is referring to? The two flats that are farthest apart, or the two flats that are closest together?

thanks in advance.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Sway bar end link top nut torque value?? [900]
posted by  miracleman49 subscriber  on Sun May 7 15:49 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.