Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

driveshaft hitting underbody after U-joint replacement 200 1984

posted by  someone claiming to be Asleeper on  Thu May 18 14:26 CST 2006 [RELATED]

I had to replace one of the U-joints on the second half of the driveshaft (the section between the center bearing and differential, I went ahead and replaced both anyways.

Upon reinstalling everything and taking the car out for a test drive, I am getting a bad vibration when accelerating from a stop. I looked underneath the car and the driveshaft yoke is hitting the tunnel right after the center support bushing. All of the bolts are tight and the center bushing is in good shape. I also have the driveshaft aligned according to the Bentley manual.

I was not having this problem before replacing the U-joints either.

Btw, the car is an 84 242 turbo with manual trans






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New driveshaft hitting underbody after U-joint replacement [200][1984]
posted by  someone claiming to be Asleeper  on Thu May 18 14:26 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.