Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

'90 245 AC conversion issue 200

posted by  xyz on  Sun Jun 4 17:03 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Jul 10 13:14 CST 2010
[RELATED]

Hello folks. Well, I converted my '90 wagon with 60K, over to r134a this weekend. Removed the compressor, changed the oil, new o-rings, dryer/receiver. Here's the problem, there's not enough room at the back of the compressor where the fittings/hook-ups are to get the r134a couplers/hook-ups on my gauge-set to fit. There's not enough clearance between the housing on the compressor and the low-side opening on the compressor to fit the hub of 134a line from my gauges. Does this make sense? Please help me. I expected this job to be straightforward , why is it not? Have other encountered this problem? There's no other low-side hook-up on the car, am I right? The old R12 hook-ups were a smaller diameter hub and so there wasn't an issue of clearance. I know that I'm not the only guy/gal to convert a '90 240 wagon from R12 to 134a on this forum.....please help....please.

Thanks

Ben Costello
'90 245 (63K)
'75 164E (47K, pristine, and soon to be sold by the way)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New '90 245 AC conversion issue [200]
posted by  xyz  on Sun Jun 4 17:03 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.