Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How to prepare a 'water flooded' motor for reuse? 200

This really isn't a volvo related question exactly. Fortunately, despite the flooding in Upstate New York, my beloved VolVolina is high and dry. My question is about a small gasoline engine I have that was under flood waters. How or what should I do to see if I can get it started again? My plan was to remove the oil and gas, remove and replace the plug and air filter and see if I could dry the cylinder with a blowdryer. Then fll 'er up and give it a try. Should I try and dismantle the engine to dry it out? Here's the joke, the egine is a small water transfer pump. The kind used to pump out basements. I had it on the lawn pumping water from the creek to water the lawn. And of course when the creek went up, it submerged the pump. Is it salvageable? Thanks for any advice. Praise Jesus the house is bone dry! Some lost lives in this great flood of '06.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How to prepare a 'water flooded' motor for reuse? [200]
posted by  VolVolina subscriber  on Thu Jun 29 13:02 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.