Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Identifying an -016 AMM 200 1993

posted by  ez_pieces on  Sun Jul 30 16:24 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jun 23 00:37 CST 2010
[RELATED]

Hi,
I have a spare AMM which is a rebuilt unit (by Fuel Injection Corp). I thought it was an -016 but it's original Bosch identification has been obliterated so I can't be sure. The only other ID on it is the Fuel Injection Corp tag which has number 78397 on it (serial #?).

I thought I would test to see if it was a working unit, so I pulled the good AMM from my 93 245 (Bosch 016) and I noticed that the internals looked a bit different.

The Bosch unit has a rectangular fin (looks like circuit board material) that must hold a thin film (?).

The other (Fuel Injection Corp) unit has a wishbone type structure with a wire running between the legs of the wishbone.

Both units have the very thin wire that runs looks sort of like a pentagon shape.
In all other respects they look the same. I have a spare 007, too, I should do a quick comparison.

Anyway, are they both -016's ??






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Identifying an -016 AMM [200][1993]
posted by  ez_pieces  on Sun Jul 30 16:24 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.