Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

cel code 1-2-1 in socket 2 (fuel injection) of '92 240........................ 200

posted by  1sciroccofahrer on  Mon Aug 21 11:30 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Mar 8 19:17 CST 2014
[RELATED]

The car started just fine today, but after my first stop I turned the car on and the cel was on for about 3 seconds before going away. This occured again at the second, and third stop, but when I went to turn the car on after the third stop the car started, and then stalled. I turned the car off, and then on again, and I had no problem getting back home.

I checked the codes and out of socket 2 I was getting the 1-2-1 code. I looked up the numbers, and it says AMM sensor signal absent or faulty. The Chilton manual has a pretty good write-up about how to use a multi-meter to test the AMM, so I will start there. Any other suggestions would be greatly appreciated.

p.s. Is it possible that the AMM would case my relatively high numbers when I went to smog the car a few weeks back-especially with the NOX? Thanks in advance!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New cel code 1-2-1 in socket 2 (fuel injection) of '92 240........................ [200]
posted by  1sciroccofahrer  on Mon Aug 21 11:30 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.