Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Installing motor in '88 780 700

posted by  clerick on  Wed Aug 23 13:10 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Aug 9 01:56 CST 2011
[RELATED]

I picked up a used motor and went through it before i put it in...

I'm trying to reinstall it and am having SERIOUS issues getting the engine to match up to the bellhousing... i can get within a half inch or so and it stops. After the fact it was suggested that the motor be pulled with the tranny, since that ship has sailed doesn anyone have any suggestions? I have checked to make sure that there arent anythings in the way, and i checked the splines on the inside of the TC and the input shaft and there are no signs of damage on any of them.

Any help would be appreciated.

Jesse Erickson






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Installing motor in '88 780 [700]
posted by  clerick  on Wed Aug 23 13:10 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.