Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2014 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Anyone replaced an AC idler bearing/pulley? 200 1993

posted by  Jessie on  Sun Sep 3 13:08 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Jan 18 17:45 CST 2011
[RELATED]

My AC compressor is howling when the AC is not engaged. I have a good used pulley bearing assembly. The NSK bearing in it looks and feels almost brand new. I am just not sure how to replace it. The Bentley was not very much help.

From what I can see there is an allen bolt in the center that must hold the clutch assembly. I tried to remove the screw but the whole clutch spins when you try to take it out. I don't see any obvious way of holding it to get the bolt loose.

Any tips would be appreciated. Will I need some kind of puller or will the old one just slide off?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Anyone replaced an AC idler bearing/pulley? [200][1993]
posted by  Jessie  on Sun Sep 3 13:08 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.