gents,

i did a stupid, costly mistake, i bent the edge of the new tab. i did the other side weeks ago just fine. really amateurish stuff.

i did a quick install with the tab tool incorrectly and it was misaligned when i installed it--couldn't see it because the tab tool brace was blocking the view.

i'll probably cut the new tab out.

questions:
1) any ideas how to remove it? heat?
2) if i cut it out, i guess i should go buy the saws-all. any recommendations on which one?
3) should be easy to cut out, right??

well, you buy the tools when you need them.

thanks all again,
byron golden
86 245
92 245