Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

EFI wiring question: (-) coil input to ecu, where? 200 1987

posted by  rob02 on  Tue Oct 17 09:55 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Jul 6 16:13 CST 2007
[RELATED]

I'm retrofitting the EFI setup/wiring from this junkyard '87 volvo to my BMW 2002. The problem I'm having is that I didn't get the coil wiring with the EFI harness. From pictures of 240s and from my memories, I can only recollect that the coil wires went down into some abyss, and I can't figure out where they go from my Bentley wire diagrams. I basically need an rpm input from my coil to the ecu, but can't tell where it should go. Any help?

From my EFI harness, the only empty connectors I have are:
The big grey rectangle one from the firewall that has 4 wires: red, yellow, black and yellow/blue wire in it
The black one from under the intake with 2 wires: greyish or tan-ish and orange wires in it
Grey one from inside passenger compartment next to ecu with 4 wires: red, red/black, white/black, yellow/red

could it be any of these above wires?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New EFI wiring question: (-) coil input to ecu, where? [200][1987]
posted by  rob02  on Tue Oct 17 09:55 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.