Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2024 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

replacing the clutch on an '83 240: rotating the tranny to get it out? 200

posted by  montysano on  Sun Nov 26 15:10 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu May 29 16:46 CST 2014
[RELATED]

Hi all,

According to my manual, once you have the transmission unbolted on a 240 manual, you have to rotate it to get it out. During this rotation, is the transmission shaft still stuck into the pilot bearing, or do you back it out some, then rotate? In other words, is there the potential to damage the shaft and/or pilot bearing during this operation.

I'm pretty clear on what's involved in replacing a clutch, except for this rotation thing. I assume that you have to keep the transmission supported during the rotation? Sounds tricky.

Thanks,

monty






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New replacing the clutch on an '83 240: rotating the tranny to get it out? [200]
posted by  montysano  on Sun Nov 26 15:10 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.